User's Manual

Guide to the SRX800 Receiver Preliminary
The first line in the display updates to show which unit has been selected (e.g. F).
Change the unit for pressure via:
Codelog > 2)Scan > 1)Continue to log data > 2)View > 2)Temp, pressure units > 2)PSI/m
The first line in the display updates to show which unit has been selected (e.g.
PSI).
CH AN G I N G T H E SE T DE L T A FR E Q U E N C Y
When adjusting the frequency manually via the keypad, the receiver increases or
decreases the frequency (in kHz) to scan by an amount equal to the Frequency
Delta increment.
Set this increment via:
Codelog > 2)Scan > 1)Continue to log data > 3)Set Delta > 1)Freq
CH AN G I N G T H E SE T DE L T A GAI N
When incrementing gain manually via the keypad, the receiver uses the Set Delta
gain increment to advance to the next gain value.
Set this increment via:
Set Delta > 2)Gain
ST AR T I N G /VI E W I N G A GPS AC Q U I S I T I O N
Start acquiring a GPS 2D position by pressing the GPS key on the keypad (key
number 4). While attempting to acquire a position, the LCD shows the number of
satellites as they are found.
If a valid position is acquired the following information is provided in the
display: Latitude, Longitude, current date, current GMT time, the number of
satellites used, HDOP, and PDOP. The LCD alternates between showing the
Latitude and Longitude information for four seconds and the satellites, HDOP,
and PDOP information for two seconds. Either the time or the date is also shown
on the display and is updated every five seconds.