User Manual

a) If you switch from plasma cung to TIG welding quite oen,
consider buying a LOTOS 3 way valve kit to connect both the
argon tank (Figure 1.7) and the air compressor simultaneously.
- Connect your TIG torch and ground cable to the front panel of the machine.
- Make sure the ground cable is connected on the right hand side where the “+” sign is located
- S e t T I G We l d / S  c k We l d / P l a s m a C u t t o T I G We l d m o d e ( r e f e r t o F i g u r e 1 . 4 , p a g e 2 )
- Set “2.5S/5S” to “2.5S” mode.
- Set “Machine/PEDAL” to “Machine” mode.
- Adjust current dial from 10 to 200 amps (Figure 1.8).
Figure 1.5 Figure 1.6
Figure 1.7
Figure 1.8
Output
from
Air
Compressor
Argon
Regulator
Argon
Gas
Machine
Gas
Inlet
Air
Compressor
15-20
min/L
5-pin
Switch
Plug
TIG
Torch
Output
3