Full Product Manual

21
Installation Manual and Operating Instructions
Put the BOLT into METAL BOLT CASE and align with the top of
the BASE PLATE. Insert BOLT with METAL BOLT CASE onto the
BASE PLATE.
INSTALLATION
8
Fit the cone packing and plastic washers onto the bolts from below the toilet,
and then tighten the nuts securely.
5
Bolt
Metal Bolt Case
Base plate
Bolt
Metal Bolt Case
7
Install the main unit and insert the
mounting bolts to the toilet
mounting holes.
Flip the base plate with bolt/metal
bolt case upside-down and slide into
the grooves at the bottom of the
unit, slide until it snaps in place.
6
Position the SHS to your toilet bowl
Holding the bolts
slide in the base plate.
DO NOT MOUNT Base Plate to toilet bowl. Follow step 6.
Cone Packing
Washer
Nut
1
2
3
9
Connect the exible tube from side of T-Valve to
SHS unit, Open the Angle Stop valve to ll water.
The Flexible Tube
Use the Spanner
* Check for any water leaks.
(TEFLON tape is strongly recommended to prevent leakage at all T-Valve
and exible tube connections.)