Full Product Manual

23
Installation Manual and Operating Instructions
In case you need to remove the SHS unit from the toilet bowl,
follow these steps.
If you pull the unit without pushing the drain button, the unit will not be separated from base plate.
INSTALLATION
7
SEPARATION OF UNIT
FROM THE TOILET BOWL
1
Disconnect the power plug
2
Shut o the Water Supply Angle Valve.
Turn o water and seat temperature.
3
Push and hold the button on the right side
of the unit to completely drain the water
from water tank.
4
Separate the unit from toilet as Shown below.
Do not turn unit upside down.
5
Disconnect the hose from the T-Valve unit (Refer to page # 20).
Please wait ve minutes and once you feel the
seat/water is hot then the unit is ready to be
adjusted to your desired temperature
12
3
6
9
5 6
SEAT
WATER
Once the water tank is full, push the water and
seat temperature button to red LED.