Installation Guide

FIGURE 11
Cutting line
FIGURE 12
LEFT RAIL RIGHT RAIL
A B A B
Measurement to floor
Subtract for rubber shoe
(-¼”) (-¼”) (-¼”) (-¼”)
Rail cut length
TABLE 2
B. With a straight edge, measure distances from middle
section to floor, for both A & B lengths (Figure 11).
Record the results in the space provide in table 2. Take
measurements for both the left and right rails.
C. Complete the table: Subtract ¼” from each measurement and record in table 2 in row titled
“Cut Length”
D. Transfer these dimensions to the bottom section of the ladders right and left rails and draw
a cutting line between the two points. Trim bottom section to length using wood saw.
E. Install rubber tread to bottom ends of rail using 1” screws provided. Drill ⁄” pilot holes
into wood prior to installing screws to prevent splitting of rail (Figure 12).
Proceed to “Check the length after making your cuts” on page 9...
7