Installation Guide

CEILING HEIGHT RAIL CUT FOOT CUT
7’ 7” – 7’ 8”*
Figure 13, step #3 E
7’ 9” – 7’ 10”
C E
7’ 11” – 8’ 2”
C D
8’ 3” – 8’ 5”
C no cut
8’ 6”
Figure 13, step #2 no cut
8’ 7” – 9’ 1”
B no cut
9’ 2” – 9’ 3”
A no cut
9’ 4” – 9’ 9”
Figure 13, step #1 no cut
9’ 10” – 10’ 2”
no cut no cut
TABLE 3
*7’ 7” to 7’ 8” ceiling
heights require
drilling mounting
holes. Use foot as
drilling template.
Bottom section side rail
FIGURE 13
Aluminum feet
D E
STEP 3:
Cut not marked
on rail
STEP 2:
Cut not marked
on rail
STEP 1:
Cut not marked
on rail
C B A
ALUMINUM MODELS ONLY:
A. Using a tape measure double check the height of the ceiling.
B. Determine the location to cut the ladder and ladder feet for your ceiling height from table 3.
C. Cut the side rails and ladder feet (when required) at the appropriate line.
NOTE: The rail is not pre-marked for angle cuts required below a step (see Figure 13).
D. Press down on the climbing section to ensure that the folding arms are fully extended.
8