Manual

PAGE 14 of 28
CONNECTION TO A DVR, VCR OR OTHER RECORDING DEVICE:
Remove the jumper (fig 9A) that connects the Audio Input Jack[38] to the Audio Output
Jack [39] located at the rear of the DG-MA. Using a dual RCA cable, connect the Audio
Input Jack[38] of the DG-MA to the Audio Output Jack of the recorder. Connect the
Audio Output Jack[39] of the DG-MA to the Audio Input Jack of the recorder. See Fig. 9
below.
INPUT
OUTPUT
AUDIO
IN
OUT
RCA CABLES
AUDIO
REAR OF DG-MA
INPUT
OUTPUT
AUDIO
JUMPER
REAR OF DG-MA
Fig. 9 Connecting to a Receiving Device
RECEIVING DEVICE
Fig. 9A Jumper Connection
NOTE:
If DG-MA is not connected
to a recording device,
jumper must be plugged
into the audio input and
output. Otherwise DG-MA
will not receive audio from
the remote microphone.
LOUROE ELECTRONICS 6955 VALJEAN AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]
Website: www.louroe.com Email: [e-mail]
(818)
INSTALLATION AND OPERATING INSTRUCTIONS
DG-25III 2/08