Manual

OPERATION AND TEST (cont.):
13). Set the alarm time delay as follow:
a. Connect the second test cable with a 3.5mm stereo plug on one end and a 3-pin
din plug on the other (supplied) between the Alarm Delay Output Jack[23] and
the Alarm Delay Input Jack[8]. See Fig. 17 above. Plug the 3.5 mm plug to the
Alarm Delay Output Jack[23] of zone 1 module (first from the left).
b. Push the Tester Reset Pushbutton[11]. The time shown on the Alarm Delay
Indicator [18] should reset to “0.0” (zero). The time is measured in seconds.
c. Starting with zone 1 module, push and released immediately the Tester Trigger
Pushbutton[10]. The unit will go into alarm. The Alarm Indicator LED[2] will
turn from green to red.
d. Check the reading on the Alarm Delay Indicator[18]. It should indicate the
factory setting for the length of time the alarm should stay on before the unit goes
into alarm (0.1's).
e. If the required time delay for that zone needs to be increased, flip the Time Delay
Switch[5] upwards.
f. Push the Tester Reset Pushbutton[11] to reset the time delay to zero as shown
by the Alarm Delay Indicator[18].
g. Push and release quickly the Alarm Delay Setting Pushbutton [19] the number
of times necessary to attain the correct time delay.
h. Push the Tester Trigger Pushbutton[10]. Zone 1 will again go into alarm.
i. Check the reading of the Alarm Delay Indicator[17]. The new time is now
indicated. If the time is still below the desired time, repeat steps 13f thru 13i.
j. If the required time delay needs to be decreased, or after performing step 13g, the
time goes over, flip the Time Delay Switch[5] downwards.
k. Push the Tester Reset Pushbutton[11] to reset the time to zero.
l. Quickly push and release the Alarm Delay Setting Pushbutton[19] a number of
times necessary to attain the desired time.
m. Push the Tester Trigger Pushbuttton[10] Zone 1 will again go into alarm.
n. Check the reading of the Alarm Delay Indicator[18]. The new time is now
indicated. If the times is still below the desired time, repeat steps 10k thru 10m.
PAGE 22 of 28
Fig. 17 Setting the alarm time delay
7
19
5
23
8
5
INCREASE
DECREASE
INCREASE
DECREASE
INCREASE
DECREASE
LOUROE ELECTRONICS 6955 VALJEAN AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]
Website: www.louroe.com Email: [e-mail]
(818)
INSTALLATION AND OPERATING INSTRUCTIONS
DG-25III 2/08