Manual
Table Of Contents
8 9 10
11 12
13
15
POWER
SET-UP CONTROLS
MONITOR
TALKBACK
ZONES
E
L
OUROE
L ECTR ON ICS
TIME
DELAY
THRESHOLD
SENSITIVITY
SENSITIVITY RESET
NON-ALARM
MONITOR
ALARM INPUT
ALARM DELAY INPUT TIME RESETTRIGGER POWER
ALARM LEVEL
ALARM DELAY
14
DG-25III
AUTO-RESET
OFF
ON
PAGE 3 of 28
[8] Alarm Delay Input Jack Used for testing the length of alarm delay settings as shown by the
Alarm Delay Indicator[18].
[9] Day/Night Sensitivity Switch Selects day or night sensitivity.
Switch operations:
a). UP position- selects night sensitivity. Used in conjunction with the
Night Sensitivity Setting Pushbutton[20]
b). DOWN position- selects day sensitivity setting. Used in
conjunction with the Day Sensitivity Setting Pushbutton[21].
[10] Tester Trigger Pushbutton Used to initiate a test alarm to set and determine the length of the
alarm time delay setting as shown by the Alarm Delay
Indicator[18].
[11] Tester Reset Pushbutton Resets Alarm Delay Indicator[18].
[12] Reset Switch Resets all zone alarms simultaneously.
[13] Tester Power Switch Turns ON power to the tester section of the unit.
[14] Non-Alarm Monitor Switch Used to listen or monitor any or all the zones even when no alarm
has occurred. Audio from any or all zones that have been switched to
“monitor” (Zone Selector Swtches[1] in UP position) can be heard at
the Monitor Speaker[36] located in the DG-MA unit.
[15] Auto-Reset Knob Cancels the alarm after a set period of time and returns the unit in
standby mode. Time can be set from 3 seconds to 3 minutes. Turn
knob clockwise to ON position. Continue rotating to desired time
setting.
Fig. 1 DG-25 Front Panel LayoutIII
LOUROE ELECTRONICS 6955 VALJEAN AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
Website: www.louroe.com Email: sales@louroe.com
(818)
INSTALLATION AND OPERATING INSTRUCTIONS
DG-25III 2/08
ON/AUDIO ALERT