Manual

PAGE 2 OF 2
MICROPHONE SENSITIVITY SWITCH
The microphone pre-amp (PC board) contains a sensitivity
switch with two positions marked N and L, and is located on the
back side of the Model A near the terminal block:
N represents normal sensitivity
(0 dB @ 1,000W)
L represents lower sensitivity
(-6 dB @ 1,000W)
Microphone is always shipped in the N position. For less
microphone sensitivity, move slide switch to L position.
BAREBARE
A B CA B C
B AC K SI DE O F
V E R I FA C T B
M I C R O P H O N E
B A C K S I D E O F
V E R I FA C T B
M I C R O P H O N E
LL
NN
BLACKBLACK
REDRED
TO LOUROE BASE STATION
OR
AUDIO INTERFACE ADAPTERS
(IF-1, IF-2, IF-4, IF-8)
A = +12Vdc (RED)
B = Audio (BLACK)
C = Ground (BARE)
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]
Website: www.louroe.com Email
[e-mail]
INSTALLATION AND OPERATING INSTRUCTIONS
2 Conductor shielded cable, 22
gauge with a 24 gauge drain wire
NOTE: Unshielded cable is not
satisfactory for audio systems
WIRING REQUIREMENTS
West Penn 452 or equivalent
AA
BB
CC
BLACKBLACK
BAREBARE
REDRED
BMIC 1/08