Instructions

CONNECTION TO A LOUROE BASE STATION OR TO IF-1, IF-4, IF-8 INTERFACE ADAPTER:
After microphone connection has been made, run cable to the Louroe Base Station or Interface Adapter.
All Louroe Base Stations and Interface Adapters have a corresponding terminal block (A, B, C) for each
zone. Make connections to the terminal block from microphone wire, matching A to A, B to B and
C to C. If using cable from other manufacturers with a different color code, make certain that wire colors
are properly matched between microphone and base station.
CONNECTION TO A LOUROE MICROPHONE MIXER (RN-2 or MLA-6)
Refer to Installation Instructions for the specified mixer.
IF MODEL K MICROPHONE IS BEING CONNECTED DIRECTLY TO A SOURCE OTHER THAN A
LOUROE BASE STATION OR INTERFACE ADAPTER (DVR, IP NETWORK CAMERA, ETC),
CONNECT AS FOLLOWS:
1. Apply 12Vdc power to terminals A and C.
(A is positive, C is negative)
2. Connect Terminal B (audio out) and Terminal C of Verifact K Microphone to the recorder or audio
source using single conductor shielded cable, 22 gauge with a drain wire.
3. If the audio input of the recorder (or other source) is an RCA receptacle, solder on an RCA plug
with terminal B wire going to tip of jack, and terminal C wire soldered to sleeve of jack.
PAGE 2 OF 3
MODEL K MICROPHONE INSTALLATION INSTRUCTIONS
MICROPHONE CONNECTION:
On the back plate of the Verifact K is a terminal strip
marked A, B, C:
A = 12Vdc (positive) Red Wire
B = Audio Out Black Wire
C = Ground (negative) Bare Wire
Using recommended wiring,wire:
1 - Connect RED wire to terminal A
2 - Connect BLACK wire to terminal B
3 - Connect Bare wire to terminal C
LOUROE ELECTRONICS 6955 VALJEAN AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]
Website: www.louroe.com Email: [e-mail]
Corel/Instructions/k mic (pdf)n 3/07
2 Conductor shielded cable, 22
gauge with a 24 gauge drain
wire.
West Penn 452 or equivalent
NOTE: Unshielded cable is not
satisfactory for audio
systems.
WIRING REQUIREMENTS
VERIFACT MODEL K MICROPHONE
WITH SHOCK MOUNT ASSEMBLY
MODEL K MICROPHONE
MOUNTING SHOE
MOUNTING PLATE
NYLON WASHER
LOCK NUT
SHOCK ABSORBERS
(Screws provided)
(6-32x¾)
IMPORTANT: Make certain that wires are
attached to
microphone’s terminal
strip BEFORE installing
microphone to shock
mount assembly.