How-To Guide

Lovehoney x Juno Rechargeable Music-Activated Panty Vibe
Symbols:
● 4 Speeds
● 7 Patterns
● USB rechargeable
How to use your
music-activated knicker vibe
● Charge the bullet vibrator by plugging the USB cable into a USB charging point, and
the electrical connector into the base of the toy.
● Charge the remote control with the same USB charging cable. The remote will flash
with blue and white lights as it charges and show solid light when it is fully charged.
● The bullet vibrator and remote control will take approximately 60 minutes to fully
charge and will give you up to 40 minutes of play.
● Slide the bullet vibrator into the silicone case, so that the button shows at the bottom.
Slip the vibe into the front of your knickers, so that the mound sits snugly against your
clitoris.
● To synch your toy to music, pick a tune with plenty of bass, turn it up loud, and place
the remote control close to the source of the sound. Press and hold the round button
on the remote control until the blue light flickers, then press and hold the button on
the bullet vibrator until the light shows.
● To use the toy without music, press the round button on the remote control again so
that the white light shows. Press it again to explore the 7 patterns. Press the plus
and minus buttons to adjust the intensity level – there are 4 speeds altogether. Press
the round button on the controller again when on the 7
th
pattern to return to music
mode.
● You can also use the bullet vibrator without the remote. Press and hold the button on
the bullet vibrator until the blue light shows. Press repeatedly to explore the 2 speeds
and 6 patterns.
● To turn off your toy, press and hold the button on the bullet vibrator, then press and
hold the button on the remote control.
● Use water-based lubricant to enjoy your toy at its best.