Indoor Furnishings User Manual

ManualsBrandsLowel Light ManualsIndoor FurnishingLOWEL CASELITE 4

Opening the Unit 2

Stand Mounting 2

Tilting & Pointing 2

Controlling Light Intensity 3

Fuse Change 3

Lamps & Lamp Changes 3

Light Controls 4

Barndoor/Intensifiers 4

Egg Crates 4

Gel Clips 4

Closing/Transporting 4

Problems, Repairs & 4

Lowel Caselite

Instructions

The Lowel Caselite is a profes-

sional lighting system. Read

these instructions and lamp man-

ufacturers’ warnings before oper-

ating.

n Do not leave Caselite unattended.

For non-stationary (portable

location) use.

n Not for household use. Use only

for photo graphic lighting (video &

film imaging).

n Do not exceed maximum rated

wattage for unit.

n Use maximum 55 Watt lamps.

n Always unplug unit before relamping.

n Be sure lamp is securely seated

in lamp socket.

n Do not use near standing water.

n Internal ballast produces high

start-up voltage.

n Never bypass plug’s ground pin.

n Do not interfere with unit’s

ventilation.

n When attaching to overhead pipes

or grids, always use a Safety Cable.

n Do not attempt to open unit,

no user serviceable parts inside.

See p. 3 for fuse change.

n This is a portable location light.

It complies with UL 1573 for still

photographic lights when used with

the supplied T1-80 cable. For use as

a portable stage lighting unit use

with Lowel T1-808 10’ unswitched

cable rated for ‘hard service’.

Fluorescent Warnings

n Avoid looking directly at the tubes

for extended periods of time.

n Fluorescent tubes contain highly

poisonous mercury.

n In the event of lamp breakage,

avoid contact with broken pieces.

n Read lamp manufacturers

information fully.

LOWELCASELITE 4

LOWELCASELITE 2

Caselite 4 Uses 4 lamps

Caselite 2 Uses 2 lamps

General Warnings Contents

Summary of content (4 pages)

PAGE 1
Lowel Caselite® Instructions The Lowel Caselite is a professional lighting system. Read these instructions and lamp manufacturers’ warnings before operating. n Do not leave Caselite unattended. For non-stationary (portable location) use. n Not for household use. Use only for photo graphic lighting (video & film imaging). n Do not exceed maximum rated wattage for unit. n Use maximum 55 Watt lamps. n Always unplug unit before relamping. n Be sure lamp is securely seated in lamp socket.
PAGE 2
Caselite® Operations Opening the Unit Stand Mounting Tilting & Pointing Laying the Caselite down, with its rear mounting adaptor facing up, release the twist-locks and lift the fixture half straight up off the lid half. Lay the fixture down with its exterior facing up. Release the interior flap locking straps on the lid to allow opening of the storage compartment. Remove the Mounting Plate, Stand-fitting Tilt-bracket (& Uni Sr. Stand, if stored in lid).
PAGE 3
Caselite® Operations Controlling Light Intensity Caselite 2 Switch Light intensity is controlled through the individual lamp switches. In each Caselite, the first tube is controlled by the AC switch in the power cable and remaining lamps are controlled by the switch(es) on back of fixture. A To turn the fixture on, Click the power switch on the AC cable. This will turn lamp 1 on.
PAGE 4
Lowel Caselite® Instructions Light Controls Barndoor/Intensifiers The dual purpose Barndoor/Intensifiers add versatility & output to the Caselite. With the mirror-finish Intensifier side facing in towards the lamps, output can be increased by approximately 40% depending on door positioning. The black Barndoor side can be useful in trimming the spill & output of the fixture. To reverse the doors, open them fully & loosen the twist-locks on the black side.