User Manual

10 |
StructureScan HD | Installation
Step Mount
Mounting the StructureScan transducer under the step not only
protects the transducer from hitting objects in the water, but does
not cause any drag on your boat when it is on plane.
Step Mount Supplies (not included)
1/8” Drill bit (Transom mount
pilot holes)
Marine grade above- or below-
waterline sealant
To use Step Mount:
1. Choose a transducer location.
2. Route the transducer cable to the location where the StructureScan mod-
ule will be installed.
3. Move the transducer bracket into the desired position and then use a pencil
to mark the pilot holes through the slots in the bracket.
4. Drill the pilot holes.
5. Apply a high-grade above- or below-waterline sealant to the pilot holes.
6. Align the bracket slots over the pilot holes and fasten the bracket to the
transom using your drill and the supplied screws.
7. To make adjustments to transducer position, loosen the screws and slide
bracket up or down.
8. Connect the transducer cable to the StructureScan module sonar port.
Step