User Manual

| 11
StructureScan HD | Installation
Direct/Step Mount (No Bracket)
When using the direct mount installation shown below, you MUST
turn on the Flip Left/Right feature. Refer to your Operation manual
for more information..
Direct Step Mount Supplies (not included)
3/32 Drill bit (Direct/Step
mount pilot holes)
Marine grade above- or below-
waterline sealant
To use Direct Mount:
1. Make sure the boat’s step is the same length or longer than the StructureS-
can transducer.
2. After selecting a mounting location, route the transducer cable to the loca-
tion where the StructureScan module will be installed.
3. Hold the transducer in the desired position and then use a pencil to mark
pilot holes through the mounting holes on the transducer.
4. Drill the pilot holes.
5. Apply a high-grade above- or below-waterline sealant to the pilot holes.
6. Align the transducer mounting holes over the pilot holes and mount the
transducer to the step using self-tapping metal screws (not supplied). Do
NOT overtighten the screws; otherwise you could strip out the fiberglass
pilot holes or crack the mounting holes on the StructureScan transducer.
7. Connect the transducer cable to the StructureScan module and then turn
on the Flip Left/Right feature on your display unit.
Do not install
under boat hull!
Direct mount
(without bracket)
¼ NOTE: When using a Direct Step Mount, you must turn on the Flip
Left/Right feature in your display unit to ensure what is shown on
the left/right side on your display, corresponds with what is on the
left/right side of your boat.