User Manual

8 |
StructureScan HD | Installation
Transom mount
The StructureScan transducer can be mounted just like a skimmer
transducer, where it is in the water when you are on plane or can be
mounted so it is only in the water, when you are moving at trolling
speed.
Transom Mount Supplies (not included)
1/8” Drill bit (Transom mount
pilot holes)
Marine grade above- or below-
waterline sealant
Transom Mount (Aluminum Hull) Supplies (not included)
M4 Machine Screws
Marine grade above- or below-
waterline sealant
Starboard (prevents corrosion between bracket and aluminum
hull)
To Mount StructureScan transducer on Transom:
1. Choose a transducer location and then route the transducer cable to the
location where the StructureScan module will be installed.
2. Place the transducer bracket against the transom and then align the bot-
tom of the transducer with the bottom of boat. Use a pencil to mark the
pilot holes through the slots in the transducer bracket.
3. Drill the pilot holes into the boat’s transom.
4. Apply a high-grade above- or below-waterline sealant to the pilot holes.
5. Align the bracket slots over the pilot holes and fasten the bracket to the
transom using your drill and the supplied screws.
6. To make adjustments to transducer position, loosen the screws and slide
bracket up or down.
7. Connect the transducer cable to the StructureScan module sonar port.