User manual

6. Check the fit of the unit, and use a file to remove any remaining

obstructions. If water-tightness is required, apply a thin,

continuous bead of sealant to the back of the unit prior to final

installation. Sealant should be of a ‘neutral cure’ type to prevent

damage to the plastics.

7. Secure the unit with screws (not supplied). For recommended

screw size and type, refer to the mounting template. Once

screws are fully tightened, ensure there is complete contact

with the mounting surface.

8. Press the four corner clips back into position.

Installation | ELITE Ti Installation Manual