User manual

Secure the cable to the hull at regular intervals using cable P clips or

saddles and ensure that moving parts such as an outboard motor or

boarding ladder cannot snag the cable.

Adjusting the transducer

If the sonar image shows interference lines on the screen when

moving, which worsen with speed, it may be possible to eliminate

these by adjusting the angle of the transducer.

Note: A transducer that is tilted too far in either direction

does not perform well; missing targets, or losing the

bottom at speed.

If performance does not improve with tilting, try adjusting the

height of the transducer relative to the transom of the boat. If the

transducer is too high it may be seeing cavitation caused by the

trailing edge of the transom.

Mounting the transducer | ELITE Ti Installation Manual