Instructions

Power connection
The plug of the supplied power cable has two discrete cables
exiting from it.
The thickest of the two cables provides power into the system (red
and black wires) and a yellow wire which is not used. Leave the
yellow wire disconnected and tape or heat-shrink the end to
prevent shorting.
The other cable is for connecting to NMEA 0183 devices.
+
_
2
3
4
5
6
1
1 Power cable
2 12 V negative wire (black)
3 Not used (yellow)
4 12 V positive wire (red) shown with fuse holder installed
inline
5
6
Vessel’s 12 V DC supply
NMEA 0183 cable
The unit can be powered on and off using the power button on the
front of the unit.
Transducer connection
The unit has internal CHIRP, Broadband, and StructureScan sonar.
Wiring | ELITE Ti Installation Manual
27