Instructions

A
A Keel offset, for example: - 0.3 m (- 1 ft)
Before setting the keel offset, measure the distance from the
transducer to the bottom of the motor - see illustration. If, for
example, the distance is 0.3 m (1 ft), it will be input as (minus) - 0.3
m (-1 ft).
Water temperature calibration
Temperature calibration is used to adjust the water temperature
value from the sonar transducer to match the data from another
temperature sensor. It may be required to correct for localized
influences to the measured temperature.
Calibration range: -9.9° - +9.9°. Default is 0°.
Ú
Note: Water temperature calibration only appears if the
transducer is temperature capable. Check transducer type
selection if this option should be available.
Transducer type
Transducer type is used for selecting the transducer model
connected to the sonar module. The transducer selected will
determine what frequencies the user can select during sonar
operation. In some transducers with built-in temperature sensors,
the temperature reading may be inaccurate or not available at all if
the wrong transducer is selected. Transducer temperature sensors
are one of two impedances - 5k or 10k. Where both options are
Software Setup | ELITE Ti Installation Manual
37