User Guide

ManualsBrandsLowrance ManualsOtherGLOBALNAV II

Pole Mount

First,

thread the

pole mounting adapter

onto the

mounting pole

ratchet base.

Align

the

pole mounting adapter

so the module will face

the bow of the boat. Install and

tighten

the set screw into the

pole

mounting adapter

and

tighten

securely.

This should

prevent

the OPS

I I •.•

IIIII

JilItIfl.

1J.Jfl..

I It4L LI i.#

._LoI".,I.'J.jL'.J

LI fl.

JLJI

mounting adapter.

Now attach the cable to the GPS module and

pass

the cable

through

the

gasket, pole mounting adapter,

and

pole.

Set the

GPS module on

top

of the

pole mounting adapter

and

align

the four

threaded holes in the module with the holes in the

pole mounting

adapter. Using

the four stainless steel 5 mm screws and lock washers

supplied

with the GlobalNav

II,

attach the

pole mounting adapter

to the

GPS

module. This

completes

the

assembly.

If the

pole

or mast

you're using

isn't hollow or if the hole in the middle of

the

pole

is too small forthe

connectors,

use the cable

mounting adapter

supplied

with

your

unit. Thread the cable

mounting adapter

into the

GPS

pole mounting adapter.

Then thread the

pole

into the cable

mounting adapter.

Route the cable down the outside of the

pole.

GPS MODULE SELF-TEST

This feature tests the GPS module and returns a

special

code. This code

is of interest

only

to the service

department.

However,

the GlobalNav II

interpretsthis

code and

displays

astatus

message.

This

message

is either

"MODULE HAS PASSED" or "MODULE HAS FAILED" and shows at the

k,nltnrn n4 Ika onroon 'rho n, ,rran+ onflwn ',nrer%n n, ,n,hr,r ,, I

';Ih; tom;:Ctacttorrervi

department

if the module fails the self test. Do not

attempt

to use this

product

if it fails the self test.

To use the self test

feature,

press

the

key,

then

pressthe key

nextto the "More"

label.

Finally, press

the

key

next to the "OPS Module Self

Tesf' label. The screen shown

right appears.

To exit from this

screen,

press

the

key

next to the "Exit" label.

GPS SIMULATOR

This feature

places position

and

navigation

data on all

screens,

including

the

plotter.

The unit

"navigates"

a closed course. It shows

bearing

and

distance to

go,

course over

ground,

and other information. A

recurring

message appears, alerting you

that the simulator mode is enabled. Don't

navigate

when the simulator is on!

To turn the simulator

on, press

the MENU

key,

then

press

the

key

next to

the "More" label.

Finally, press

the

key

next to the "GPS Simulator OFF

ON" label.

The

simulator

mode

starts

immediately.

To turn the simulator

off,

either

press

and hold the OFF

key

repeat

the above

steps.

MODULE

C Mo&tle Self Test

POLE

MOUNTING

ADAPTER

SET

scREw

Bit

Summary

Low Order Rami

High

Order Rami

Pre Process Test

Pre Process Rae

Multi Interface

'JCO Test

Signal

INJ.

Software Version

POLE

Modale Has PASSEO

MODULE

CABLE

MOUNTING

ADAPTER

POLE

CABLE

MOUNTING

ADAPTER

POLE

6 43

PDF compression, OCR, web-optimization with CVISION's PdfCompressor