User Guide

DISPLAY CONTRAST
Surface
Mounting
-
Without Access
The unit's
display
contrast is
adjustableto
suitdifferent
light-
ing
conditions. To
adjust
it,
first
press
the menu
key,
then
press
the
key
next to the "More" label
______________________________
two times. Now
press
the
key
nextto the
"Adjust Display
Con-
trast" label. A screen similar to
__________ ___________ ___________
the one at
right appears.
Now
press
the
key adjacent
to the
left arrow to decrease the con-
trast. Press the
key
adjacent
to
the
right
arrow to increase it. The
percentage
of contrast in use
changes
as the arrow
keys
are
pressed.
The bar chart also
gives
a
graphical
indication of the contrast level. You can see the
change
on the screen as
you press
the
keys. Afteryou've
made the
adjustment, press
the CLR
key
to erase the menu.
ADJUST BACK LIGHT
LEVEL
The GlobalNav II has internal
lights
for the
display
and
key-
board. To
adjust
the
intensity
of the
lighting, press
the MENU
key,
then
press
the
key
next to
the "More" labeltwotimes. Now
press
the
key
next to the "Ad-
just
Back
Light
Level" label.
Thescmenshownbelowappears.
If
you
don't have access to the back side of the
mounting
surface,
use
the "cleats"
supplied
with the GlobalNav II.
(Note:
This is
assuming
you
can "snake" the module's cable to a location that is accessable. A
hole will still need to be drilled in the
mounting
surface for the
cable.)
Using
the
gasket
as a
template,
mark and drill the 17 mm
(11/16")
hole
for the
cable. Attach the cable to the
module and
drop
the other end of
the cable
through
the
gasket
and down the hole. Place the module on
the
gasket.
Slide the "cleats" onto each end of the module and
(using
the cleats as
templates)
mark four holes for 5 mm
(#10) mounting
screws. Drill the
holes,
then
replace
the cleats on the module and
fasten them to the
mounting
surface with 5 mm
(#10)
screws. Route
the cable to the GlobalNav II.
"cLEAT"
Now
press
the left arrow
key
to
decrease
the
light
level. Press
the
right
arrow
key
to increase
it. The
percentage
of back
light
in use
changes
as the arrow
keys
are
pressed.
The barchart
also
gives
a
graphical
indica-
tion of the level. After
you've
made the
adjustment, press
the CLR
keyto
erase the menu.
GPS MODULE
r
CURRENT POSITION
H 36° 08.993'
950 50.552'
2 2
0
12:iu;ji ill
MPH MAG
2/19/1993
0.15 MI 77°M
oo:oo:55
MARK AND
DRILL FOUR
PLAcEs
ffTii?&iiTiN
1
36° 09.002'
950 50.389'
____________ _____________
IU(mIlirY
2 2
o
1z:n:tu ii,
. MPH MAG 2/19/1993
I I
IRE
0.01 M 338°MAG
99:99:99
GASKET
CABLE
44
5
PDF compression, OCR, web-optimization with CVISION's PdfCompressor