Operation Manual

127
2. The Transfer My Data menu includes a message that tells you if a
MMC is present or not. If no MMC is present, you must insert a card
into the unit to activate the Load or Save commands.
To transfer data from the unit to the MMC: press
ENT (for SAVE.)
To transfer data from the MMC to the unit: press
→ to LOAD|ENT.
3. Saving to MMC: To accept the default name "Data" for the GPS Data
File, press ↓ to
SAVE DATA|ENT. If you wish to rename the file (as shown in
the following figures), press
ENT to activate the Data File name selection
box. Press ↑ or ↓ to change the first character, then press
→ to the next
character and repeat until the name is correct. Then, press
ENT|↓ to SAVE
DATA|ENT.
The unit will display a completion message when the data transfer is
finished. To return to the Page view, repeatedly press
EXIT.
From left to right, these figures show the sequence for naming and
saving a GPS Data File from the unit's memory to an MMC.
4.
Loading to unit memory: There may be more than one GPS Data File
(*.USR) on the card. To select a file, press
ENT to activate the MMC Card
selection box, use
↓ or ↑ to highlight the file, then press ENT. Next, press ↓
to
LOAD|ENT. The unit will display a completion message when the data
transfer is finished. To return to the Page view, press
EXIT|EXIT|EXIT.
These figures show the menu sequence for loading a GPS Data File
from an MMC into the unit's memory.
Figure 2.
Figure 1.