Operating Instructions and Installation Instructions

213
To Reset Calibration:
Choosing the Reset Calibration command will switch fuel flow calibra-
tion settings back to factory defaults.
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight FUEL MANAGEMENT and press ENT. The Fuel Management
menu will appear.
3. Highlight to
ENGINE SELECT and press ENT. Select the desired engine —
the engine attached to the desired fuel flow — and press
ENT.
4. Highlight
RESET CALIBRATION and press ENT. The following confirma-
tion message will appear: Are you sure you wish to Reset Calibration?
Select
YES and press ENT. Calibration settings for the selected fuel have
been returned to factory defaults.
To Reset Trip:
The Reset Trip function allows you to reset to zero the running total of
fuel used on a particular trip.
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
FUEL MANAGEMENT and press ENT. The Fuel Management
menu will appear.
3. Select
RESET TRIP and press ENT. The following confirmation message
will appear: Are you sure you wish to Reset Trip? Highlight
YES and
press
ENT. The Trip Fuel Used figure has been reset to zero.
To Reset Seasonal:
Your unit can track fuel usage not only for trips, but also for entire sea-
sons. The reset seasonal command allows you to reset to zero the run-
ning total of fuel used during a season.
1. 1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
FUEL MANAGEMENT and press ENT. The Fuel Management
menu will appear.
3. Select
RESET SEASONAL and press ENT. The following confirmation mes-
sage will appear: Are you sure you wish to Reset Seasonal?
Highlight
YES and press ENT. The Seasonal Fuel Used figure has been
reset to zero.
NMEA 2000 Alarms
The NMEA 2000 Alarms menu allows you to set Full and Empty fuel
alarms for the EP-10 Fuel Flow, EP-15 Fluid Level, EP-50 Storage De-
vice and the Suzuki Engine Interface. The alarms may be set to a per-
centage (0-100%) of tank capacity.