Operating Instructions and Installation Instructions

229
Highlight
CALIBRATE TRIM and press ENT. The Device Calibration window
will appear with a list of Calibration Instructions.
4. Highlight
START CALIBRATION and press ENT. The following message
will appear: Please fully raise the Engine Trim.
5. After engine trim has been fully raised, press
ENT. The following
message will appear: Please fully lower the Engine trim.
6. After engine trim has been fully lowered, press
ENT. A Calibration
Completed message will appear. Press
ENT.
7. Repeat these instructions to adjust the engine trim for each engine
connected to a Suzuki Engine Interface. Press
EXIT repeatedly to return
to the main display.
Reset Trim Calibration
If you are not satisfied with your engine trim calibration, you can reset
engine trim calibration from the Suzuki Engine Interface Advanced
Options menu.
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Choose
BUS SETUP and press ENT. Select the Suzuki Engine Interface
connected to the desired engine and press
ENT.
3. Highlight
ADVANCED OPTIONS and press ENT. Select Reset TRIM CALIBRA-
TION
and press ENT. The following message will appear: Do you wish to
re-calibrate the device?
4. Highlight
YES and press ENT. Press EXIT repeatedly to get back to the
main display.
Bennett Trim Tabs Calibration
Trim Tabs will be calibrated through their Device Configuration menu.
To calibrate Trim Tabs:
1. Press MENU|MENU, select BUS SETUP and press ENT. A list of network
devices will appear.
2. Select
BENNETT TRIM TABS from the list and press ENT, which will open
the Trim Tab Device Configuration menu.
3. Highlight
CALIBRATE and press ENT. The Device Calibration window
will appear with a list of calibration instructions.
4. Select
START CALIBRATION and press ENT. The following message will
appear: Please fully raise Trim Tabs.
5. After fully raising the trims tabs, press
ENT. The following message
will appear: Please fully lower trim tabs.
6. After fully lowering the trim tabs, press
ENT. A Calibration Complete
message will appear. Press
ENT. Press EXIT repeatedly to return to the
main display.