Installation Guide

© 2012 Louisiana-Pacific Corporation. All rights reserved. LP, SmartSide, SilverTech and SmartFinish
are registered trademarks of Louisiana-Pacific Corporation. Printed in U.S.A.
NOTE: Louisiana-Pacific Corporation periodically updates and revises its product information.
To verify that this version is current, call 800-450-6106.
LPZB0512
Cal.Prop65Warning:Use of this product may result in
exposure to wood dust, known to the State of California
to cause cancer.
 .   . U S P
1
/
8
in. gap
1
/
8
in. gap
Scant face width
SPACE JOINT 1/8 IN.
Refer to nailing instructions
Figure 9
G, F D  W
Interior Wall
Finish
Casing
Insulation
Filler
Header
3
/
8
in. gap
Code Approved
Flashing
Trim
Nail fin
(do not damage)
Siding
Space according
to the window/door
manufacturer’s instruction
Code Approved Breathable
Water-Resistive Barrier
Figure 8



















WARRANTY REMEDIES ARE NOT AVAILABLE IF
REQUIREMENTS ARE NOT FOLLOWED.
S M N C M
Bottom plate
Extend
siding
below
sill plate
Min.
1
/
8
in. or
flashing between
siding and
masonry.
Stud
Floor system
Flashing or
moisture
barrier
Masonry
foundation
Sill plate
OR
Figure 7A Figure 7B