Instructions / Assembly

TRIM & FASCIA 190, 440, 540 & 2000 SERIES
APPLICATION
INSTRUCTIONS
A - Corners E - Board and Batten
B - Windows, Doors, Openings F - Mounting Blocks
C - Gable Ends and Barge Rafters G - Exterior Columns
D - Fascia and Rake
LIMITED WARRANTY
The Louisiana-Pacic Corporation (“LP”) LP® SmartSide® trim and fascia (the “Products”) limited warranty (the Warranty”) applies only to structures on which
the Products have been applied, nished and maintained in accordance with the published application, nishing and maintenance instructions in eect at
the time of application. Products aected by a failure to follow such application, nishing or maintenance instructions (“Aected Products”) will be excluded
from coverage under the Warranty.
LP assumes no liability for any loss or damage caused by the Aected Products and is expressly released by the purchaser or owner from any such
loss or liability.
Any modication of the Warranty or the application, nishing and maintenance requirements is void unless approved in writing by LP prior to application.
For a copy of the warranty or installation and technical support, visit the LP Web site at: www.lpcorp.com
WARRANTY REMEDIES ARE NOT AVAILABLE IF REQUIREMENTS ARE NOT FOLLOWED. or for additional support call 800-450-6106
ON SITE STORAGE
Store o the ground well supported, on a at well-drained surface. Store
products under a roof or separate waterproof covering.
(See diagram 1a)
Additional support may be required to achieve a safe clearance from the
ground.
When the waterproof covering is removed cut all unit banding.
Keep trim and fascia clean and dry. Inspect prior to installation.
PREPARATION
GENERAL REQUIREMENTS
There are no National Standards for wood composite substrate trim.
Louisiana-Pacic’s application instructions describe the minimum requirements needed to assure LP SmartSide limited warranty coverage.
Trim and fascia installations not in compliance with LP application instructions are prone to reduced service life and products subject to
such installation are excluded from coverage under the LP SmartSide limited warranty.
All exposed wood substrate must be sealed in a manner that prevents moisture intrusion and water build up.
LP SmartSide trim and fascia can be applied directly over materials such as siding, or fastened directly to structural members up to
24 inches o.c.
Trim and fascia are not designed for siding; or structural applications and should not be used as a structural member in construction such
as a trellis, railing, fencing, decking, decking trim or sills.
1a
1

Summary of content (12 pages)