Installation Guide

TRIM & FASCIA 190, 440, 540 & 2000 SERIES

GENERAL REQUIREMENTS (CONTINUED)

INSTALLATION

• Prime all exposed wood substrate before painting.

• Thoroughly paint the bottom edges of siding, especially all cut ends next to the roof line.

• Apply paint as soon as possible and within 180 days of application.

• Follow the coating manufacturer’s application and maintenance instructions.

DO NOT USE:

• Semi-transparent and transparent stain.

• Shake and shingle paints.

• Vinyl-based resin formulas such as vinyl acetate, PVA, vinyl acetate/acrylic copolymer paints.

CAUTION:

HANDLE PREFINISHED LP SMARTSIDE PRODUCTS WITH EXTREME CARE DURING STORAGE AND APPLICATION.

TOUCH UP ANY DAMAGE TO THE FINISH THAT MAY OCCUR DURING APPLICATION PER PREFINISHERS SPECIFICATIONS.

GENERAL REQUIREMENTS (CONTINUED)

Finishing Instructions

Cal. Prop 65 Warning: Use of this product may result in exposure to

wood dust, known to the State of California to cause cancer.

Louisiana-Pacic Corporation

414 Union Street, Suite 2000

Nashville, TN 37219

www.lpcorp.com

www.lpsmartside.com

SmartSide, and FlameBlock are registered trademarks of

Louisiana-Pacic Corporation. APA is a registered trademark of

APA - The Engineered Wood Association.

NOTICE: Louisiana-Pacic Corporation periodically updates and

revises its product information. The information in this document

is subject to change without notice. To verify that this version is

current, call 800-450-6106.

LPZB0766 8/17

LP SmartSide Perfection Shingle

LIMITED WARRANTY

The Louisiana-Pacic Corporation (“LP”) LP® SmartSide® Trim and Siding (the “Products”) Limited Warranty (the “Warranty”) applies only

to structures on which the Products have been applied, nished and maintained in accordance with the published application, nishing

and maintenance instructions in eect at the time of application. Products aected by a failure to follow such application, nishing or

maintenance instructions (“Aected Products”) will be excluded from coverage under the Warranty.

LP assumes no liability for any loss or damage caused by the Aected Products and is expressly released by the purchaser or

owner from any such loss or liability.

Any modication of the Warranty or the application, nishing and maintenance requirements is void unless approved in writing by LP prior

to application.

For a copy of the warranty or installation and technical support, visit the LP Web site at: www.lpcorp.com

WARRANTY REMEDIES ARE NOT AVAILABLE IF REQUIREMENTS ARE NOT FOLLOWED. or for additional support call 800-450-6106