Instructions / Assembly

ManualsBrandsLP SmartSide ManualsBuilding materialsSmartSide 440 Series Cedar Texture Trim Engineered Treated Wood Siding, Application As 2 in. x 8 ft.

TRIM & FASCIA 190, 440, 540 & 2000 SERIES

APPLICATION

INSTRUCTIONS

• Trim may be installed as fascia, without sub-fascia, if it is 440 Series or larger and the following specications are met:

- Trim and Fascia must be greater than 5 inches wide.

- Maximum roof truss or rafter spacing of 24 inches on-center.

• If trim is installed directly to outlookers on an overhanging rake, the outlookers must be installed edgewise and must be spaced no wider

than 24 inches o.c. (See diagram 9a)

• 190 Series trim and fascia products MUST BE supported with solid wood

sub-fascia.

• Trim and Fascia are not designed for structural applications and cannot

be used in the structural design of a roof assembly.

• Exposed ying or suspended barge, rake or fascia tails are not covered

under the LP SmartSide trim limited warranty if trim is extended beyond

the protection of the roof system. If LP SmartSide trim is extended

beyond the protection of the roof system, cap the top of the trim with a

metal coping that is integrated with the roong system.

(See diagram 9b)

• Install drip-edge to prevent water buildup behind fascia and trim.

(See diagrams 2c and 9c)

AT CORNERS: (See diagram 9d)

• All joints must be supported by framing.

• Do not nail from the face of one trim member into the edge of another.

• Do not miter cut the corner joint.

INSTALLATION

FASCIA AND RAKE BOARDS

Ridge

Barge Rafter

A ladder of outlookers

the same dimension as

rafters at 24” o.c. max.

Metal

Coping

1” Gutter

Clearance

3/16” space

with sealant

First Common

Rafter

End or

Verge Rafter

2x or 4x Outlookers

Fascia

First Common

Rafter

Barge Rafter

Drip-edge

Fascia

3/16” space

with sealant

Sot

Trim