User's Manual

Page 4
17 inch SXGA TFT LCD Color Monitor
(6) Fit the stand part into the stand groove of Monitor (See the following Instruction).
This equipment has been tested and found to comply with the limits for a Class B
Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, if it is not
installed or used by the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, that could be determined by tuning the equipment on and off, the
user is encouraged to try to connect the interference with the following option:
• Re-orient or relocate the reception of antenna.
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that which the
receiver is connected to.
• Consult the dealer or an experienced Radio / Television technician for help.
2. U.S. FCC CLASS B NOTICE
(7) Adjust the tilt of your monitor.
(8) Turn on PC and TFT LCD monitor.
(9) Adjust the display. (SXGA, 1280x1024 pixels, 24 bit color)
* Disassembly of Stand
To disassemble the stand from your monitor, press down the stand with one hand
and hold the handle of Monitor with the other hand. Pull out the monitor from the
stand shaking gently the handle of monitor right and left.
Do not pull out with excessive strength. It might damage your monitor.