User Manual

STEP 3. FINISHING THE INSTA L L ATION
Battery placement
Place the battery in an easily accessible spot with the velcro pad included. Be sure to clean the area thoroughly
before installing.
Volume wheel placement
Find a suitable location near the top inner edge of the soundhole for the volume pot. Clean the area, peel off
the backing from the adhesive and put the pot into place.
Secure all wires with the wire clips provided and re-string the uke. You are done.
 g. 3
Carefully trim here with sharp cutter.
Preparing the saddle
You will need to compensate for the thickness of
the pickup by removing approximately .030” from
the overall height of the saddle. NOTE: The  t of
the saddle is the single most important factor for
the installation. The bottom of the saddle should
be perfectly  at. The ideal saddle  t is loose
enough to remove with your  ngertips, but will
not fall out by itself.