Safety data sheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revised on / Version: 27.03.2015 / 0002
Replaces revision of / Version: 29.11.2011 / 0001
Valid from: 27.03.2015
PDF print date: 30.03.2015
LRP Magic Colour 2
Consumer Human - inhalation Long term, local
effects
DNEL 14,7 mg/m3
2-methoxy-1-methylethyl acetate
Area of application Exposure route /
Environmental
compartment
Effect on health Descripto
r
Value Unit Note
Workers / employees Human - dermal Long term, systemic
effects
DNEL 153,5 mg/kg
Workers / employees Human - inhalation Long term, systemic
effects
DNEL 275 mg/m3
Consumer Human - dermal Long term, systemic
effects
DNEL 54,8 mg/kg
Consumer Human - oral Long term, systemic
effects
DNEL 1,67 mg/kg
Environment - freshwater PNEC 0,635 mg/l
Environment - sediment,
freshwater
PNEC 3,29 mg/kg
Environment - sediment,
marine
PNEC 0,329 mg/kg
Environment - soil PNEC 0,29 mg/kg
Environment - sewage
treatment plant
PNEC 100 mg/l
Consumer Human - inhalation Long term, systemic
effects
DNEL 33 mg/m3
Environment - marine PNEC 0,0635 mg/l
Environment - water,
sporadic (intermittent)
release
PNEC 6,35 mg/l
8.2 Exposure controls
8.2.1 Appropriate engineering controls
Ensure good ventilation. This can be achieved by local suction or general air extraction.
If this is insufficient to maintain the concentration under the WEL or AGW values, suitable breathing protection should be worn.
Applies only if maximum permissible exposure values are listed here.
8.2.2 Individual protection measures, such as personal protective equipment
General hygiene measures for the handling of chemicals are applicable.
Wash hands before breaks and at end of work.
Keep away from food, drink and animal feedingstuffs.
Remove contaminated clothing and protective equipment before entering areas in which food is consumed.
Eye/face protection:
With danger of contact with eyes.
Tight fitting protective goggles with side protection (EN 166).
Skin protection - Hand protection:
Normally not necessary.
In case of direct contact with the ingredients:
If applicable
Safety gloves made of butyl (EN 374)
Protective Neoprene® / polychloroprene gloves (EN 374).
Protective nitrile gloves (EN 374)
Minimum layer thickness in mm:
0,4
Permeation time (penetration time) in minutes:
>480
The breakthrough times determined in accordance with EN 374 Part 3 were not obtained under practical conditions.
The recommended maximum wearing time is 50% of breakthrough time.
Page 7 of 17