Logic Use's Guide Network Adapter SI40919O,LSI40919LO,LSI40919H,LSI40919LH,LSI44929O,LSI44929LO, LSI44929H,LSI44929LH,ITI7004G2-LC

4-14 BIOS Features

Select the port or adapter shown (use the port name your system assigns):

ok select /pci@8,700000/IntraServer,fc@1

Then enter commands as shown in the following example:

ok show-link-speed

Link speed selected is 1 Gbaud

Current link speed is 1 Gbaud

ok set-link-speed

<- command with no arguments prints help

usage is <link-speed> set-link-speed

ok a set-link-speed

Link speed selected is autobaud

Link speed has been set

Change will take effect after system power cycle

ok show-link-speed

Link speed selected is autobaud

Current link speed is 1 Gbaud

Note: The system must be power cycled before the changes take

effect. It is not sufficient to execute the reset-all command.

4.8.7 Persistent Device Naming

Under certain conﬁgurations, such as when the Fibre Channel disk is the

system’s boot device, it may be preferable to lock a target disk to a unit

number. LSI Logic/IntraServer Fcode allows the system administrator to

write a non-volatile map of IDs to the Fibre Channel controller.

The following is an example of how to map devices in the persistent

device table.

Select the controller you want to modify, as shown in the following

example:

ok show-disks

a) /pci@1f,0/pci@1/IntraServer,fc@2/disk

b) /pci@1f,0/pci@1/IntraServer,Ultra2-scsi@1/disk

c) /pci@1f,0/pci@1,1/ide@3/cdrom