Logic Use's Guide Network Adapter LSI8751D

2-4 Installing the LSI8751D
by the edge; do not touch board components or gold
connector contacts. The use of a static ground strap is
recommended.
Step 4. Locate the slots for PCI plug-in board installation. Refer to the
user’s manual for your computer to confirm the location of the
PCI slots. The LSI8751D requires a PCI slot which allows bus
master operation.
Step 5. Remove the blank panel on the back of the computer aligned
with the PCI slot you intend to use. Save the bracket screw.
Step 6. Carefully insert the edge connector J1 (see Figure 2.1) of the
host adapter into the PCI slot. Make sure the edge connector
is properly engaged before pressing the board into place as
shown in Figure 2.2. You may notice that the components on a
PCI host adapter face the opposite way from those on other
non-PCI adapter boards you have in your system. This is
correct, and the board is keyed to go in only one way.
Figure 2.2 Inserting the Host Adapter
Bracket Screw