USER’S GUIDE LSI60800 PCI to USB Host Adapter Version 1.1 November 2000 ® S14000.
Electromagnetic Compatibility Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. 2. This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
® LSI60800 PCI to USB Host Adapter User’s Guide Version 1.1 1 What is Covered in This Guide This User’s Guide provides instructions and illustrations to help you install a LSI Logic LSI60800 PCI to USB Host Adapter.
Figure 1 LSI60800 Board PCI to USB Controller External USB Cable J2 J1 PCI Mainboard Connector . 2 Hardware Installation Before you begin the board installation, switch off the power to the computer and any peripheral devices and disconnect all power cords. Important: Before handling the LSI60800 board, ground yourself using a ground strap attached to the computer metal frame. Static charges on your body can damage electronic components.
4. Remove the LSI60800 Board from the antistatic bag and insert the edge connector into the PCI slot, as pictured in Figure 2. Make sure the edge connector is properly aligned before pressing the board into place. Apply even pressure to both ends of the board while inserting it. 5. Visually check to make sure the LSI60800 Board is properly seated, and is all the way down in the PCI slot. 6. Screw the bracket down with the screw from step 3.
3 LSI60800 Software Installation The LSI60800 Host Adapter is supported by Microsoft embedded drivers for Windows 98. After installing the LSI60800 Board, restart the computer. A sequence of windows will appear briefly one after the other. First the New Hardware Found window will appear. Then the next window will indicate that the LSI Logic LSI61C102 USB Host Controller is the device that was found. Then a window will indicate that the Controller is an unknown device.
Figure 3 System Properties Window - Device Manager Tab 5. Click on Close. 4 Connect the USB Devices 1. Load the USB device driver supplied by the USB device manufacturer following the procedure provided with the USB device. 2. Plug in the USB device using the correct cable (see below). There is no need to turn off the computer power. The USB devices can be hot-plugged. 3. The device driver should load automatically without any user interaction.
4.1 Cabling The LSI60800 PCI to USB Host Adapter supports type A cable connectors only. The USB specification provides for two types of cables. For full-speed devices like scanners, cameras, printers, and speakers, a full-speed cable must be used. For low-speed devices like keyboards, mice, joysticks, and other game devices, a sub-channel or low-speed cable can be used. 4.2 Hubs The USB specification supports two types of hubs; cable-powered and self-powered.
Notes LSI60800 PCI to USB Host Adapter 7
Notes Headquarters LSI Logic Corporation North American Headquarters Milpitas CA Tel: 408.433.8000 Fax: 408.433.8989 LSI Logic Europe Ltd European Headquarters Bracknell England Tel: 44.1344.426544 Fax: 44.1344.481039 LSI Logic K.K. Headquarters Tokyo Japan Tel: 81.3.5463.7821 Fax: 81.3.5463.7820 To receive product literature, visit us at http://www.lsilogic.com ISO 9000 Certified Printed on Recycled Paper Printed in USA Order No. S14000.A Doc. No.
