Quick Installation Guide

ManualsBrandsLT Security ManualsCamera & PhotoNETWORK CAMERA

FOR MORE INFORMATION OR THE LATEST

UPDATES CHECK OUT OUR WEBSITE:

WWW.LAVIEWUSA.COM

Type III Cube Camera

Note:

Press RESET about 10s when the camera is powering on or

rebooting to restore the default settings, including the user

name, password, IP address, port No., etc.

Installation Steps:

1. Memory Card Installation

1) Remove the memory card slot cover.

2)Insert the memory card into the slot.

3) (Optional) Push the inserted memory card to get it sprung out.

4)Replace the slot cover.

3. Buckle the camera base into the adapter plate.

4. Adjust surveillance angel

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance

with FCC’s RF Exposure guidelines, This equipment should be installed and operated with

minimum distance between 20cm the radiator your body: Use only the supplied antenna.

No. Description No.

Description

Memory Card Slot

2. Camera Mounting

This type of camera supports ceiling mounting and wall mounting.

Install the adapter plate to the wall or ceiling with the supplied

screws.

RESET/WPS

1 RJ45 Ethernet port & PoE

Power (12 VDC)

Lens

Speaker

Microphone

Indicator

PIR sensor

IR LED

A wireless router with the WPS function is required to enable

the WPS function of the camera. Refer the steps below.

1) Press the WPS button on the router.

2) Press the WPS button (about 2s) on the camera within 120s

you enable the WPS of the router to join in the wireless

network.

Slot

Cover

Wall

1). Loosen the adjusting knob 1 to adjust the panning position

and tilting position.

2). Loosen the adjusting knob 2 to adjust the rotation position.

3). After adjusting the angle of the camera to the desired

position, fasten the two knobs.

Panning:

0° to 360°

Rotation: 0° to 360°

Tilting: 0° to 90°

Adjusting

Knob 2

Adjusting

Knob 1