Manual

User Manual of 5 Inch Network Speed Dome

enable the continuous snapshot or event-triggered snapshot in Snapshot

interface. For detailed information, please refer to the Section 6.6.8 Configuring

Snapshot Settings.

6.3.9 Configuring NAT Settings

 UPnP

Universal Plug and Play (UPnP) is a networking architecture that provides

compatibility among networking equipment, software and other hardware devices.

With the UPnP function enabled, you don’t need to configure the port mapping for

each port, and the camera is connected to the Wide Area Network via the router.

Steps:

1. Enter the UPnP settings interface.

Configuration >Advanced Configuration > Network > NAT

2. Check the Enable UPnP checkbox

3. Add a Friendly Name.

Figure 6-23 Configure UPnP Settings

4. Click to save the settings.

 Port Maping

Steps:

1. Check the Enable Port Mapping checkbox

2. Select the Port Mapping Mode as Auto or Manual.

3. If in Manual mode, you can check the checkbox of HTTP, RTSP or SDK port

according to your demand.

4. Click to save the settings.