36" x 84" Parts List & Installation

Tools Needed
You will need a Pencil, Phillips head screwdriver, Tape
measure, Drill, Assorted Drill bits (5/16” & 3/8”), 6” phillips
head bit (included in kit), 1/2” socket ratchet, 4ft Level, Rubber
mallet and Safety glasses.
Parts List
Make sure ALL parts are included before beginning.
NOTE:
It is very important to determine whether you will be installing
a Mounting Board prior to installing the track. If you do need to
install a Mounting Board, it MUST be installed rst.
(Mounting Board Not Included)
PVC Barn Door Assembly and Track Installation H Style 36”
Please read ALL instructions before you begin installation.
You MUST determine if you need a Mounting Board prior to doing ANY installation. Due to many overlapping factors
such as the location of wall studs, the weight of a Barn door and the various types of trim used in homes, we
recommend using a Mounting Board in all situations. Track must be installed into Solid Blocking or Head Casing.
Fig. 6
Fig. 7
1-1/2”
4-1/2”
2”
2”
17.75
INCH
17.75
INCH
17.75
INCH
17.75
INCH
4.75
INCH
H +
3 INCH
2. Determine Track
Location
On the same side where you made
your Height mark, measure 4-3/4”
over from the door jamb and draw
a line so the 2 measurements
intersect. This will be the location
of the rst hole in the Track.
See Figure 1.
3. Insert Mounting Hardware
Drill pilot hole. Insert lag bolt (X) through the rst track hole, then
place the track spacer (S) through the bolt on back of the track.
Install the lag bolt with ½” socket ratchet. Do not tighten fully.
Swing the track up and use the level to ensure the track is straight.
Mark the remaining holes in the track. Drill remaining pilot holes.
At the other end of the track from where you installed your rst
bolt, slide the stopper (T) onto the track that is for the side where
the door will be in the closed position. Push it towards the middle
of the track. Install a bolt and spacer at this end of the track. Slide
the stopper to the other end of the track so it is between the rst
and second holes in the track. Install the remaining bolts and
spacers. Go back and full tighten the rst bolt. Slide the remaining
stopper onto the other end of the track. Do not set either stopper
at this point. Refer to Figures 2A, 2B & 2C.
Figure 1
NOTE NOTE
5 Ea.
5 Ea.
1 Ea.
1 Ea.
10 Ea.
2 Ea.
1 Ea.
2 Ea.
22 Ea.
2 Ea.
2 Ea.
1. Measure for Track Height
In order to determine the proper Height for your Barn Door
Track, add 3” to the height of the door being installed. Locate
and mark this height on the wall (or mounting board) on the
side of the door jamb where the door would be in the closed
position. See Figure 1.
2 Ea.
4 Ea.
1 Ea.
2 Ea.
5 Ea.
5 Ea.
2 Ea.
2 Ea.
2 Ea.
1 Ea.
5 Ea.
1 Ea.
Fig. 2A
Fig. 2B
Fig. 2C
Figure 2A
Masonry Application
Figure 2B
Mounting Board/Stud Application
Fig. 2A
Fig. 2B
Fig. 2C
4 Ea.
2 Ea.
Fig. 2A
Fig. 2B
Fig. 2C