36" x 84" Parts List & Installation

ManualsBrandsLTL Home Products ManualsBarn Interior DoorsPaneled PVC/Vinyl Millbrooke Barn Door with Installation Hardware Kit

PVC Barn Door Assembly and Track Installation H Style 36”

8. Attach Remaining Stile

Secure the remaining stile (A) (repeat of step #4). Make sure the side with

the large holes is facing outward. Insert one of the Reinforcement plates

(B) into the bottom of the Stile into the innermost chamber of the Stile.

Place 2 of the 4” screws (Z) into the 2 holes in the outside of the channel.

Make sure they are fully inserted. Slide a Reinforcement clip (D) into the

channel and over the screw shafts.

Place the end of the Bottom rail (C) against the screws, lining up the holes

in the extrusion. Once in place, tighten screws until stile and bottom rail

are about 1/2” apart. Do not tighten fully.

For Center Rail (E) (repeat of step #5), place 2 of the 4” screws (Z) into the

pre-drilled holes in the stile, making sure they are fully inserted. Snap a

center rail stopper (F) into the channel between the 2 screw shafts. Once in

place, snap each screw shaft into the outer channels of the stopper.

Place the Center rail against the screws, lining up the holes in the

extrusion. Once in place, tighten screws until stile and center rail are about

1/2” apart. Do not tighten fully.

Insert U bracket (G) (repeat of step #6) into the Top of the stile into the

outside channel and the innermost channel. The side of the U clip with the

larger holes should be facing the outside edge of the door. The top of the

U clip will rest on the top of the stile once inserted.

Place 2 of the 4” screws (Z) into the 2 holes in the outside of the Stile

channel. Make sure they are fully inserted. Slide a reinforcement clip (D)

into the channel and over the screws shafts.

Insert two small screws (Q) into the oval holes on the top of the U bracket

and secure to the top of the stile. Take 2 small screws (Q) and secure

into the oval holes in the outside of U bracket (G). This will be the outside

channel of the stile.

Make sure the holes in the extrusion on the Top rail (C) line up against the

screws. Once in place, continue tightening screws until stile and rail are

ush and secure. Go back and fully tighten the screws in the Center and

Bottom Rails. See Figure 12.

9. Install Roller Brackets

Line up the holes on the Roller Bracket (O)

with the U bracket (G) and secure with the 2

allen screws (Y). Repeat with the other Roller

bracket (O). See Figure 13.

10. Finishing Strips

Snap the 2 side nishing strips (M) into place. Snap the top and

bottom strips (N) into place. See Figure 14.

Figure 13

Figure 12

Figure 14

Bottom

Top

11. Install Safety Spacers

Once the Roller brackets have been secured and the

nishing strips in place, it is important to install the Safety

spacers (W). These spacers help to protect the door from being

bumped o of the track. With the door laying at in a safe and

secure position, place one of the two spacers approximately 2”

to the inside of one of the roller brackets. Place slightly o center

towards the front of the door. Using a drill, secure the spacer

with the screw provided. Repeat steps to install the second

spacer inside the other roller bracket.

See Figure 15.

Figure 15

INCH

1-1/2”