User's Manual

Card Reader
6
Color
Description
Blue
RS-485-
Yellow
RS-485+
Red
PWR (+12 VDC)
Black
GND
Gray
TAMPER (available for Wiegand Protocol)
Purple
Beep Control (available for Wiegand Protocol)
Brown
Green LED Control (available for Wiegand
Protocol)
3.3 Wiring Cables
Purpose:
Wire the cables between controller and card reader, thus to
establish the communication between them.
Steps for RS-485 communication mode:
1. Set the DIP switch of No. 6 as 1.
2. Set the DIP switch of No. 1 ~ 4 for RS-485 address. For
details, please refer to 3.1 Introduction for DIP Switch.
3. Wire the cable between controller and card reader as
shown below.