Installation Guide

American LuBann assumes no liability for improper installation.
Track and all fasteners must be mounted into wood studs or wall blocking for maximum weight capacity.
Alternatively, use a 1X4 header board with the same lenght as the track.
Tools Needed:
Pencil, philips head screwdriver, tape measure, power drill, assorted drill bits
(incl. 5/16" and 3/8"), wrench set or adjustable wrench, level, squaring tool and
wear all necessary saftey gears for personal protection.
Optional:
If the 6.6FT track comes in two short tracks, please connect the two short
tracks as in figure to make a 6.6FT track.
1
Determine track height and location
Install the track to the wall
Use a stud finder to locate wood studs and wood
blocking inside the wall as shown in figure .
Measure up from the floor "door height+1-3/4 in." to the
centerline of the track. Leave at least 2 in. from the end of the
track to the side of the door opening. Use a level to level the
track and mark screw holes. Drill 1/4 in. pilot holes.
(i.e. standoffs)