Telephones Quick Reference

ManualsBrandsLucent Technologies ManualsTelephone6218

6218 and 6220 Telephones

Quick Reference

Document Ordering No. 555-230-713

Comcode 108504333

Issue 2, August 1999

Summary of content (8 pages)

PAGE 1
6218 and 6220 Telephones Quick Reference Document Ordering No.
PAGE 2
IMPORTANT INFORMATION SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS The most careful attention has been devoted to quality standards in the manufacture of your new telephone. Safety is a major factor in the design of every set, but, safety is YOUR responsibility too. When you see this warning symbol on the product, refer to these instructions packed with the product for more information before proceeding further in the installation process.
PAGE 3
THE 6218 and 6220 TELEPHONES 6218 DATA jack Handset Parking Tab Handset Parking Tab 10 Programmable Dialing buttons 6218 Program Program button Pause button Pause Flash Redial Redial button Hold ABC DEF 1 2 3 GHI JKL MNO 4 5 6 PQRS TUV WXYZ 7 8 9 * Dial pad Flash button Redial button LINE jack (on bottom of telephone) Hold button 6220 Program Pause button Pause Tel.
PAGE 4
—— INSTALLATION —— 6. Turn the telephone right-side up and place it on your desk or table. 7. Plug one end of the coiled handset cord into the handset jack on the side of the telephone. 8. Plug the other end of the handset cord into the handset. 9. Hang up the handset. 10. Plug the free end of the line cord into a modular wall jack. 11. Lift the handset and listen for dial tone. ) to 12. Set the Ringer volume control (labeled the setting you want.
PAGE 5
7. Plug one end of the coiled handset cord into the handset jack on the side of the telephone. 8. Plug the free end of the line cord into a modular wall jack. 9. Place the telephone against the wall jack mount and push down so that the base locks into the slots on the telephone. 10. Plug the free end of the coiled handset cord into the handset and hang up the handset. 11. Lift the handset and listen for dial tone. 12. Set the Ringer volume control (labeled ) to the settings you want.
PAGE 6
To label and reinstall the programmable dialing buttons designation card on your telephone 1. Remove the plastic card cover from the telephone by placing your fingers at the top and bottom and flexing the card outward. Then, lift the button designation card from out of its cavity on the telephone. 2. In the blank space next to the appropriate programmable dialing button, write or type the name or telephone number that you want to store there. 3. Place the designation card back on the telephone.
PAGE 7
REPAIR INSTRUCTIONS To program Hold for normal Hold (that is, the feature which allows the user to put a call on hold) 1. Press the Program button; then press Flash ; then press Hold . 2. Press Hold again; then press Flash again; finally, press the Program button again. If it is determined that your telephone is malfunctioning, the FCC requires that it not be used and that it be unplugged from the modular outlet until the problem is corrected.