Telephones Quick Reference

ManualsBrandsLucent Technologies ManualsTelephone6225

6220 and 6225 Telephones

Quick Reference

Document Ordering No. 555-230-713

Comcode 108179540

Issue 1, June 1998

Summary of content (8 pages)

PAGE 1
6220 and 6225 Telephones Quick Reference Document Ordering No.
PAGE 2
IMPORTANT INFORMATION SAFETY INSTRUCTIONS The most careful attention has been devoted to quality standards in the manufacture of your new telephone. Safety is a major factor in the design of every set, but, safety is YOUR responsibility too. Please read carefully the helpful tips listed below and on the next page. These suggestions will enable you to take full advantage of your new telephone. Then, retain these tips for later use.
PAGE 3
THE 6220 and 6225 TELEPHONES Personalized Ring Power jack (on 6225 only) DATA jack Ringer volume control Handset 10 Programmable Dialing buttons 6220 Program button Mute button and Mute light Program Pause button Pause Tel.
PAGE 4
—— INSTALLATION —— Use the following directions to mount the telephone on a standard wallphone jack with mounting studs. TABLE/DESK INSTALLATION Use the 7-foot straight line cord that came with your telephone to connect the telephone to a modular jack. ! WALL INSTALLATION WARNING: Do not plug the handset cord into the line jack or the data jack on your telephone since it could damage your handset and the telephone. 1. Turn the telephone upside down so that you can see the bottom of the telephone.
PAGE 5
9. Place the telephone against the wall jack mount and push down so that the base locks into the slots on the telephone. 10. Plug the free end of the coiled handset cord into the handset and hang up the handset. 11. Lift the handset and listen for dial tone. 12. Set the Ringer Volume Control switch (labeled ) to the settings you want. —— PROCEDURES —— ANSWERING AND PLACING A CALL To answer or place a call NOTE: The Message light flashes when a call is coming in (that is, when the telephone is ringing).
PAGE 6
• You hear a rapid error tone if you try to enter more than 24 elements, and you will exit Program mode without saving the new number. • You can use the Pause button to program a 1.5-second pause between a dialing access number, such as 9, and the telephone number, and for certain banking and long-distance services. • For example, to put a pause between the dialing access number, 9, and the telephone number, press the Pause button, then 12125551234.
PAGE 7
— FCC Information — INTERFERENCE INFORMATION ! FCC REGISTRATION AND REPAIR INFORMATION Your new Lucent Technologies telephone has been registered with the Federal Communications Commission (FCC). This product complies with standards in Part 68 of the FCC rules.