Switch Router Adapter Owner's Manual

SP Switch Router Adapter Guide - 1.4 Update 2 Index-1
Index
520MB spinning disk, configuring, 2-6
9076, 9077
9077 installation overview, 2-5
9077 support on SP web page, D-1
system names, 1-3
what these refer to, 1-3
A
AC power supplies, 1-4
active connections, netstat -an, 3-10
Admin Status (MIB parameter), 2-34
administrative network
router’s Ethernet cable, 1-4
topology diagram, 1-2
alias address, in grifconfig.conf, 2-21
argument field, in grifconfig.conf, 2-23
ARP
as used in SP Switch networks, C-2, C-3,
C-5
ARP mismatch
switch route not found, 3-21
ARP table
grarp command, 3-3
how to flush, 3-20
maint display command, 3-20
attaching cables, 2-10
procedures, 2-11
autojoin option, 2-40
B
bad packets from switch, 3-23
binaries, specify different, 2-24
boot and reset LED activity, 1-9
boot errors, indicated by LEDs, 1-9
boot messages, gr.boot log file, 3-32
BOOT-REQUESTED, state of, 2-37
bridging
collect data via grdinfo, 3-26
broadcast address, in grifconfig.conf, 2-22
C
cables
attaching to SP Switch Router Adapter
card, 2-10
factory-shipped components, 1-3
from SP Switch Router to Ethernet hub,
2-10
SP control workstation-to-SP Switch
Router, 1-4
attaching, 2-10
SP Switch cable connector end, 1-6
SP Switch-to-SP Switch Router, 1-3
attaching, 2-10
to Ethernet hub from SP Switch Router,
2-10
card profile
change default dump settings, 2-25
ICMP settings, 2-24
individual card configuration, 2-24
specify different run-time code, 2-25
communications bus traffic, UDP, 3-19
community names, and spenmgmt, 1-17
configuration
assumptions, 2-3
installing configuration files, 2-35
SNMP procedure, 2-18
configuration examples
multiple SP partition, multiple cards, C-6
recovery at card failure, C-5
single SP partition, multiple cards, C-3
single SP partition, single card, C-2
configuration files
for SP Switch Router Adapter card, 2-16
configuration parameters
installing on card, 1-18
Configuration State (MIB parameter), list of
states, 2-34
configuration via SNMP, 1-15
configuration, network
examples, see Appendix C
CONFIGURING, state of, 2-37
connection options, 1-3
connection status, netstat -an, 3-10