Lucent Technologies Bell Labs Innovations CIB 3020 (506A2) 10-Basic Telephone Module (61311) (105211049) CIB 3020 Comcode 103983946 Issue 4 January 1997 .
ADDENDUM (CIB 3020) T/R STATION MODULE ® NOTE: THE USE OF A TRIMLINE TELEPHONE IS NOT RECOMMENDED WITH THIS UNIT 845554724
CIB 3020 10-Basic Telephone Module The 10-Basic Telephone Module (Figure 1) allows you to connect up to ten basic touch-tone or rotary telephones to your Model 1030 or 3070 communications system. Up to six 10-Basic Telephone Modules can be installed in both your control unit and expansion unit, allowing a total of 60 basic telephones to be connected to your communications system.
Installing the 10-Basic Telephone Module WARNING: Before removing or inserting modules in the control unit or expansion unit, be sure to turn the power switches to the off position in both units. This module can be mounted in slots labeled 10 or 11 in the control unit or slots labeled 21, 22, 23 or 24 in the expansion unit. The slot labeled 9 in the control unit must be equipped with a Voice Terminal Module. (If you use the slot labeled 24, you will also need an additional power supply.) 1.
4. Align the module in the slot (Figure 3), making sure the edges of the circuit board are in the top and bottom grooves of the slot. Figure 3 Installing the Module (Typical) 5. Slide the module into the slot until the latch at the bottom of the module catches at the base of the slot. With one hand, press firmly at the front of the module while using the other hand to snap the latch into place.
Removing the 10-Basic Telephone Module To remove the module from the control unit or expansion unit, turn the power switches to the off position, disconnect the modular cords from the 10-Basic Telephone Module and press down firmly on the latch at the module’s base until it releases Slowly slide the module out of the slot Administering the Basic Telephones Connected to Your 10-Basic Telephone Module To assign lines to your basic telephones and administer access to outside lines, refer to the information be
FEATURE MODULES 4 AND 5 Refer to your administration manual’s Section titled “Special lnformation About Basic Telephones” for instructions, NOTE: If you have a pooled system and want people with basic telephones to: ● ● receive calls on lines in different pools (other than the main pool), assign the pools to their telephones in the same way as they are assigned to voice terminals (see the section titled “Assigning Line Pools to Buttons”) make outside calls on pooled lines (including Automatic Route Select
Lucent Technologies Bell Labs innovations Copyright © 1996, Lucent Technologies All Rights Reserved Printed in U.S.A.
