IP Phone User Manual

Removing the 10-Basic Telephone Module

To remove the module from the control unit or expansion unit, turn the power

switches to the off position, disconnect the modular cords from the 10-Basic

Telephone Module and press down firmly on the latch at the module’s base

until it releases Slowly slide the module out of the slot

Administering the Basic Telephones

Connected to Your 10-Basic Telephone Module

To assign lines to your basic telephones and administer access to outside

lines, refer to the information below to locate the appropriate section of your

administration manual for further instructions.

FEATURE MODULE 1

● If you have a square system, follow the instructions in the section titled

“Assigning Individual Lines and call Restrictions to Voice Terminals” in

your administration manual with the following exception: you cannot ad-

minister the lines connected to jack A0 and A1 in the control unit for

basic telephones People with basic telephones cannot place calls or

receive transferred calls from these lines, or any other lines you do nol

administer for their telephones Be sure that people with basic telephones

have access to all the Iines they need to use.

● If you have a pooled system, follow the instructions in the section titled

“Creating a Line Pool” in your administration manual. People with basic

telephones dial 9 to access the line pool. If you assign additional lines

to their telephones, people dial 88 to access an available line. Since

the system selects the first available line, be sure to assign inter-

changeable lines within the pool and lines to the telephone.

FEATURE MODULE 2

Refer to your administration manual’s section titled “Special Information About

Basic Telephones” for instructions.

NOTE: If you have a pooled system and want people with basic telephones

to receive calls on lines in different pools (other than the main pool), assign

the pools to their telephones in the same way as they are assigned to voice

terminals (see the section titled “Assigning Lines and Line Pools to Buttons”

in your administration manual). Outside calls cannot be made on these pooled

lines, but they can be received.

FEATURE MODULE 3

Refer to your administration manual’s section titled “Special Information About

Basic Telephones” for instructions.