user manual

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-58ANL-16-L (16-Port Neon Analog Line)
10
1018 ABORT The test has been disabled via administration. The default for the ’Test’
field on the ’Station’ form is ’y’; thus, you may want to determine why this
field has been set to ’n’ on this station (this may be due to the brief ringing
disturbance that this test may cause).
1. To enable the test for the particular analog station being tested, enter
change station extension and set the ‘Test?’ field on the station from
'n' to 'y.'
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate necessary system resources to run this test.
1. Retry the command at one-minute intervals a maximum of five times.
FAIL The terminal equipment is not connected to the circuit pack. Some terminal
equipment such as modems may fail even when connected properly.
1. Remotely test the equipment.
2. If the test fails again, look for RING-GEN errors in the error log. If
present, refer to the RING-GEN (analog ring generator) Maintenance
documentation.
3. Check all of the wiring between the station equipment and the switch.
Then, run the test again.
4. If the test still fails, the set may be defective. Check the set, and
replace it, if necessary.
5. Some terminal equipment could fail even when it is connected
properly. If this is the case, disable the test using the change station
extension command (enter 'n' into the Test field). Note that this action
also disables tests 6, 7, 161, and 35 on this port.
PASS The station is connected properly to the switch. This test may also pass if
no terminal equipment is connected and the terminal is located very far
from the switch. User-reported troubles on this port should be investigated
by using other port tests, by examining station wiring, or by examining the
station.
Table 10-24. TEST #48 Station Present Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page