user manual

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-982M/T-PKT (Maintenance/Test Packet Bus Port)
10
Packet Bus Port Health Inquiry Test (#567)
This test verifies that the Packet Bus fault detection maintenance function of the
Maintenance/Test Packet Bus Port is functioning properly. This is done by having
the Maintenance/Test Packet Bus Port perform a self-test. If this self-test passes,
then the Packet Bus Port Health Inquiry Test passes. If the self-test fails, or the
SPE cannot communicate with the Maintenance/Test Packet Bus Port, then the
test fails.
Table 10-284. TEST #567 Packet Bus Port Health Inquiry Test
Error
Code
Test
Result Description/ Recommendation
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT System resources necessary to run this test are not
available.
2500 ABORT An internal operation failed; the test could not be
completed.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
2059 FAIL The Maintenance/Test Packet Bus Port has reported a
failure of the on-board self-test.
2060 FAIL The Maintenance/Test Packet Bus Port has reported an
invalid state for the Packet Bus.
2061 FAIL The SPE cannot communicate with the
Maintenance/Test Packet Bus Port, but is able to
communicate with the Maintenance/Test Circuit Pack.
1. Retry the command.
2. If the test continues to fail, replace the
Maintenance/Test circuit pack and retry the
command.
3. If the test continues to fail, refer to PKT-BUS
Maintenance documentation to determine if the
M/T-PKT failure is being caused by a Packet Bus
fault.
PASS The Maintenance/Test Packet Bus Port Packet Bus fault
detection capability is operating correctly.
Continued on next page