user manual

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1293STBY-SPE (Standby SPE)
10
2054 ABORT This indicates an incompatibility between the two Processor circuit packs in a
Duplication Option system. Follow the repair steps for STBY-SPE error 139 note
(k).
2068 ABORT When attempting to refresh Standby SPE memory from Active SPE memory, a
problem was encountered when refreshing Packet Control circuit pack
memory.
1. Retry the command at 1-minute intervals a maximum of 5 times.
other ABORT Any ABORT with an error code other than the ones listed previously indicates a
problem that prevented the test from running. See Test Result of each
maintenance object under test for details.
other FAIL Any FAIL indicates that the test was actually run on the associated Standby
SPE component. However, the test did not succeed and returned FAIL with the
reason for the failure. See Test Result of each maintenance object under test
for details.
PASS The test was actually successfully run on the associated Standby SPE
component and returned PASS. See Test Result of each maintenance object
under test for details.
Table 10-392. Test Result Error Codes Associated with the Standby SPE
— Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page