user manual

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1300STRAT-3 (Stratum 3 Clock)]
10
Maintenance documentation. Before switching back to the new
TN780 Tone-Clock circuit pack, use the test tone-clock PC long
command to check that the Tone-Clock is receiving a signal from
the Stratum 3 clock. The notation "PC" denotes a port network
number and carrier. If all tests pass, switch to the new Tone-Clock
circuit pack via the set tone-clock PC override command. If Test
#651 fails, then the original TN780 Tone-Clock should be
reinserted, and the cable between the Stratum 3 clock and the
TN780 Tone-Clock circuit pack should be replaced. If Test #651
continues to fail, then escalate the problem.
c. This error indicates that the Tone/Clock circuit pack in the master port
network is not a TN780 Tone/Clock circuit pack when a Stratum 3 clock is
administered. Verify that the Tone/Clock in the master port network is
TN780.
d. This error indicates that the Stratum 3 clock has either reference A or CI
card A failed. Please refer to the error code 1 in the test description of the
Test #649 for the repair procedure.
e. This error indicates that the Stratum 3 clock has one power supply failed.
Please refer to the error code 2 in the test description of the Test #649 for
the repair procedure.
f. This error indicates that the Stratum 3 clock has one clock unit failed.
Please refer to the error code 4 in the test description of the Test #649 for
the repair procedure.
g. This error indicates that the Stratum 3 clock has either reference B or CI
card B failed. Please refer to the error code 8 in the test description of the
Test #649 for the repair procedure.
h. This error indicates that the Stratum 3 clock has all power supplies failed.
Please refer to the error code 16 in the test description of the Test #649 for
the repair procedure.
i. This error indicates that the Stratum 3 clock has all clock units failed.
Please refer to the error code 32 in the test description of the Test #649 for
the repair procedure.